Recent content by thelegendofpiter

You can do some 3d maps manually, I already did a few models with metashape and the result is very good I have to say! You just need to setup the auto shot o time shot i don't rememebr the name, and then slowly fly aound the buildings you want to recreate or the area you want to scan. It's quite...

It’s not happening , but only in sport mode and going sideways, after the replacement and a recalibration of the camera it works better now. My main problem is that the camera doesn’t go back to 90 degrees after the stop, as it is suppose to be...

mine one does the same. I asked the assistance but it seems that they are not aware of the issue, they replaced my drone but the problem still persists

So do you confim that is a common issue and not something wrong with my gimbal right?

Nice!! tomorrow I'll give it a try

I contacted the support and after a firmware refresh, done with the DJI assistant 2 for Mavic software and a complete re-calibration of sensors, compass, etc, now the issue (if it's an issue) appears only in sport mode

The fact is that it doesn’t go back to 90 degrees after the stop, I have to manually turn it down again

Hi guys I have a problem with the gimbal. Basically when I’m going forward with the camera facing down at 90 degrees and I stop the drone the gimbal rotates upward to something like 80-83 degrees. I just ran out of battery but I’ll make some other tests in the afternoon. Should I change...

I got some minor bugs in the editing section...

Thanks a lot for the thorough answer! That’s exactly what I was looking for! I’m quite good at repairing electronic stuff (I usually repair iPhones and iPads for friends / family) and after seeing the tutorials I think that I can handle the reparation without problem and hopefully everything...

I agree with you, I asked a similar question and at the end I went for a cheaper and brand new Mini instead of a more expensive and second hand Pro. You’ll never know if it has been even used / stored / charged / properly. I’m perfectly fine for second hand electronics but a drone is a really...

Do you have a rough idea about how much this will cost me?

Hi! I found an (hopefully) good deal with a Pro that fell down from roughly a 1.5m height can fly without problems. It's sold for 350 € and the main issue is a glitchy gimbal that works (can take pictures) but it cannot move fluidly, it does some small steps to rotate. Do you think that it can...

That's for sure.

You're right but I got the feeling that is kinda a software issue most of times rather than an hardware one. Like a faulty RTH or the wrong band chosen by default... I watched ton of tests and comparison and even some hacks like the remote "mod" to install the 4hawks extender: With all that...