Recent content by turtle

Thank you so much!

As the others have said, thank you so much Thunder! Your help is much appreciated. Is there any where I can purchase a replacement for that part? Or would I need to replace the whole gimbal. If so, may I ask what you would charge for such a repair if I send it in?

Ok so tried to take a couple of angles. Some to show the scuff marks on the area I believe is scratching and then some to show where the two collide and the friction is.

That cable is part of the ribbon cable that needs to be replaced correct? If so, then I will just have that redone when I order the new part. Do you sell those parts btw?

Attempted to snap anything in and around the area highlighted but nothing felt out of place or able to snap in even when using my fingernail.

When I google Mavic Pro gimbal almost every picture has that cable displayed in a similar fashion. What do you think is wrong with this one?

I trust that you know way more than me and likely most people on this forum however this is a completely new gimbal plate that I installed this morning which is why I was also confused about the obstruction. Don’t recall any hits for the drone and drone was fine last time i used it, several...

If this is what you are talking about (refer to picture) nothing seems out of place and nothing to snap in that isn't already in place.

Very weird because although I see how it looks straight in this picture you can definitely feel and hear the rubbing of that piece and even can see the scuff marks on the picture I sent you where it is rubbing.

Any advice as to how to make it look right?

@Thunderdrones Sorry for not being more clear!

@Thunderdrones ok seems I am clear on that side but now it seems a new obstruction was created. Now the gimbal arm is rubbing against itself. Any idea how to fix that properly?

Thank you @Thunderdrones! Is there a specific way to bend the gimbal plate? Do I need to remove the gimbal again from the screws or can it be bent while still connected?

Drone was new when I purchased it about 2 years ago. However, I have only flown it a handful of times in those 2 years. Last time I flew it was in in August and I don't recall having any problems. Took it out two days ago to fly and the error for motor overload popped up. Noticed the bracket was...

Don't have a 3D printer but currently in need of what I think is considered the roll motor back cover as it would leave the wires exposed. Seems to be common that these parts get hairline cracks that overtime break off. Currently have it taped but if anyone is selling these or knows someone who...