Recent content by Wildman7221

I agree as well.

After trying everything I could think of to move the camera angle, before cutting the glue out of the crack I repaired, I decided to cut the glue out and turn the gimble motor. As seen in the pics, this is where the index dot should be! It is operating perfectly now and took it on a few flights...

Yes, I sure did. Even when I max out at 10.0 on the horizontal, it only brought it not quite a ⅓ of what it needs to go. What is really weird is that when I go into gimbal calibration Auto mode, it instantly levels out the camera, horizontally, while going through the calibration and then at the...

I used a drop of locktite super glue on the crack of the frame and its has the motor where it won't move. I am actually thinking about using my Dremel and open the crack back up to allow the motor to move. I just don't know where to index the dot to if I did move it.

I've tried both the python command strings to calibrate my gimbal, as an administrator, without success. It goes through the motions of calibration and recenters the camera to point straight forward but the camera does not show level to the horizon. It will still be about 40 or so degrees...