My Mavic Air was under water for 10-15 minutes (salt water) After lot of cleaning everything worked but no propell goes. Changed ESC board and propels start going, but now there’s no image from camera. Gimbel working and I get error 4 message. Can also not set drone in camera mode, in photo mode...
I drop my Mavic Air in salt water. Washed in fresh water right after. Everything almost working. I get ECS error and when I check overall status it says 3No and 4No. I think this means motor 3 and 4?? Is motor 3 and 4 on the back? Sorry for bad English.
Hi.
I was flying with my MA today and get this message several times. Attitude was not high. The real heigh could be around 20-30 meter but it show sometime -0 meter.
I used this low noise propellers but I dont think this was the reasen. What could be wrong here?
Never jused RTH function before, because I felt safe with short distance, so it was first time I tryed RTH and was happy to see it worked perfect[emoji106]
Its depend witch mode you use. If you use CE mode you not get so long distance. In FCC Mode its better. I schould get longer than 2km in FCC mode but I’m satisfied anyway [emoji4]
RTH was set to 30m, strange was camera went stright to the ground few second and then went forward again and start flying home. Maybe MA measure to get some status first.
After I feel more comfortable to fly my MA I tryed to see how far I can fly.
After about 2km I lost controll of it and lost picture. MA is programmed to «go home» if lost signal and after short time I get signal and MA was on a way home [emoji4]MA is also worked as it should.
My quistion is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.