Sorry. It was a while back when i was trying to do this. I am not sure which number i was changing to what. It was what i was told at the time but it could have been wrong. I shall try later today with the numbers you have just given
i’m not at all sure about warranty issues but i recently tried to chance S mode to Atti, going through various steps very carefully with the correct downloaded software. Unfortunately, it seems that DJI have jumped in and now disabled this ability. If anyone has been able to do it just now on...
I have followed the instructions to the letter. The software i downloaded was 2V1.1.2 which i suppose is the same as V1.1.2 but i can’t find the latter anywhere. So my problem is that when i change the value from 12 to 3 it does not hold. It immediately reverts to 12 no matter what i try.
I think i have done something daft. After Synchronizing my flights on the “me” section of the app i then deleted them to free up space. But where have they been synchronised to? Have i just deleted the lot permanently?
The attached screen grab is after calibrating the sensors again. are the slider bars supposed to show full green across left to right or is this all fully calibrated? If not properly calibrated I don’t know what I am doing wrong.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.