Recent content by zenonn

Unfortunately, batteries with this type of chemistry are like small children. More attention is needed. There are several things, that over the years and my experience with this type of battery allow me to use them for a very long time. Batteries do not like fast charging and rapid discharge, as...

Fear of something, prevents you from thinking. If you realize that there is no point in worrying about the things that are in your control as well as the things that are not in your control, everything will be much easier and pleasant. That takes time, of course. I usually don't use RTH, but...

There is, but I wouldn't comment on it.

OK. Can you check if they are in the same row ie. is a pin not sunk in?

Hello! Would you look at the electrical outlets on the drone? Check if there is any problem with them. Or take a picture and post it here.

Search on YouTube. There is a lot of information on this topic. You may also need to familiarize yourself with DJI Battery Killer so you can set up the new package properly. Plus, you'll have to figure out how to properly store your batteries so they don't swell anymore.

Diagnose, repair, change the battery controller setting...etc. Google is your best friend...

DJI Battery Killer

@ mucek https://drive.google.com/file/d/1ShTGz_VTgNTsbzEU11a9Vy_zxFUGjeqs/view?usp=sharing DJI Battery Killer

I'm sure that DJI... they do not sleep, and use every minute to fix "holes" in their software, so that they meet the requirements of the region in which they sell. I guess if an RC with an older firmware is found, it will clarify where the problem is.

In some cases an OTG cable is required to trigger FCC hack apk ON. In my case, if I use the cable that comes with the RC, nothing happens, but with the OTG cable, it's OK

Actually, something like that was going through my head. Unfortunately, my area of expertise is very far away, otherwise I would take up this idea with great pleasure.

I'm not familiar with all the possible 3D printing materials, but I'm wondering, if there is a suitable material, isn't it possible to print them instead of having them manufactured by someone? This is a very superficial reasoning, but if it is possible, then the benefit for everyone will be...

My confusion is as a result of "These speeds...", assuming it refers to all measured RPMs and at the same time "at 9639 rpm it starts to climb". Now it's clear.