Air 3 with Mavic 3 props on back

[MavicShooter]

So first the props from the mavic 3(current gen) do fit the rear engine on the air 3. I did have to gently shave off a little from the batttery pinch points but did not penetrate any plastic.

Have been able to get 39min hover time comfortably at 390’ with the stock A3 up and the stock M3 in back.

Recently went with the the Stealth A3(front) and stealth(M3) and got about the same hover time, however I got 47.7mph

 

[Rob Dog]

I would be very careful with that (as I am sure you were) ... Messing with the props can alter a lot of things. How did you make sure the weights were uniform etc???

 

[MavicShooter]

I would be very careful with that (as I am sure you were) ... Messing with the props can alter a lot of things. How did you make sure the weights were uniform etc???

Of course. Did a test flight before hand to see controls were working etc.

Weights weren’t measured, but I did measure where the screws are inputted as I have had issues with these backing out before

 

[Meta4]

Recently went with the the Stealth A3(front) and stealth(M3) and got about the same hover time, however I got 47.7mph

Congratulations .. you managed to get your Air 3 to fly as fast as the specs say it can.