Breaking

[Gracey]

When flying my Mavic 2 Zoom using the Smart Controller I receive the following on the screen. "Breaking, re-set toggles then continue flying."
This might not be the exact message, but close.
Any information on this.
Thanks
Chris

 

[msinger]

That message means the front sensors have detected an obstacle. If there were no obstacles ahead of your Mavic, then that could have been caused by flying toward the sun.

 

[MikeyMikeOZ]

I get that same error at times. Usually, as stated by @msinger, on very bright days. Full tilt forward, my MP has mistaken a mailbox shadow as a hazard, and I was flying at around 10' altitude... I had to keep doing high speed passes to figure it out.

If you are positive there are no obstacles to contend with, (at your own risk) you can turn off the forward obstacle avoidance and that should resolve your issue.

 

[bishop penster]

This is happening to me as well a lot the other day...it was cloudy and there was no sun visible and i was flying away from the sun anyway.... any ideas what is causing this?

 

[msinger]

any ideas what is causing this?

Find anything useful in the flight log? If you haven't looked, you can upload and view your TXT flight log online here:

DJI Flight Log Viewer | Phantom Help

Upload and view DJI Phantom, Mavic, and Spark flight logs online

www.PhantomHelp.com