Can't take off mini 2 after props change
- Thread starter David88
- Start date
Are you sure you have the correct props on the corresponding motors?
Atkas
Well-Known Member
No, that I can see from the blade shapes you have you have an incorrect mixture.
The blades on the right front (RF) and left rear (LR) motors should have a raised section near the hub, the blades on the left front (LF) and right rear (RR) motors should haveon NO raised section near the hub. The RF & LR arms have cast in grooves near the motor to correspond with the raised section near the blade hubs, the LF & RR arms have no such grooves.
The blades on the right front (RF) and left rear (LR) motors should have a raised section near the hub, the blades on the left front (LF) and right rear (RR) motors should have
Last edited by a moderator:
After reading your message I checked and for some reason they were not, the A were on B, that was the issue (I noticed they have a little hump to distinguish)
I appreciate it
I just took a look at was you said and that was the issue, thank you very much!
cheddar-man
Well-Known Member
careless
Well-Known Member
I purchased a Mav mini from OfferUp and the add said "needs repair" but the only thing I could find wrong was the props installed wrong.
It is SO easy to screw up which props go on which motors. If I recall, the Mini 1 props used to have different stripes on the ends of the props to make them easier to identify. I just took a look at my Mavic 2 and saw that the props and motors were "color coded" white circle and just black to easily match up the right props on the right motors.
I wish DJI went back to striping or something to identify which are A and B props. If you need one or the other you cannot tell which is which while still in the package. The last time I changed props it seemed like more of a challenge for visual identification unless you're Philius and can remember which prop goes where by how the raised section is near the motors.
I wish DJI went back to striping or something to identify which are A and B props. If you need one or the other you cannot tell which is which while still in the package. The last time I changed props it seemed like more of a challenge for visual identification unless you're Philius and can remember which prop goes where by how the raised section is near the motors.
