Couldn't match same settings in Hyperlapse as Youtube tutorial.

[Bunraku]

Hi

There is a youtube tutorial video of nightlapse where the guy uses a 2.5s shutter speed, with a 3 second interval and a length of 10 seconds.
However when i set my shutter speed to 2.5s the hyperlapse would not go to an interval below 5 seconds and a maximum length of 7 seconds.
The only way i could get a 3 second interval and a 10 second length was to change the shutter speed to 1 second.

Any idea why?

Link to video here and bear in mind it's the nightlapse and not the daylapse.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

Thanks

 

[Runnikee]

Hi

There is a youtube tutorial video of nightlapse where the guy uses a 2.5s shutter speed, with a 3 second interval and a length of 10 seconds.
However when i set my shutter speed to 2.5s the hyperlapse would not go to an interval below 5 seconds and a maximum length of 7 seconds.
The only way i could get a 3 second interval and a 10 second length was to change the shutter speed to 1 second.

Any idea why?

Link to video here and bear in mind it's the nightlapse and not the daylapse.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

Thanks

I had something similar happen (I've been trying to learn Hyperlapses also) and what I figured out was the duration of the final video that I set was not long enough to allow for longer shutter speeds, which is why it had to lessen the length. When I lengthened the duration, I was able to get the shutter speed length that I wanted. In other words, there was not enough duration of the final product to take hyperlapses with a longer shutter speed. Try making your duration longer and see if that helps. You can always shorten your hyperlapse later during editing.

 

[TrabSeyn]

Try setting up your waypoint hyperlapses with a fresh battery. I was getting this behavior and noticed the drone would only allow for 3-5 second sequences when I tried to set up the flight after flying around for roughly 10 minutes. Swapped out a battery and was able to setup the sequence at 8-10 seconds, save the flight, return and swap into a 3rd battery for the photos. I think the app is calculating the remaining battery into the sequence setup. Give it a try and see if this solves the issue.