DJI AIR 3S Start

[FlyCeara]

Friends
My DJI AIR 3S won't start when I tap RC2 on the screen or through stickers.
When I start the RC2 and drone, no error message appears.
The motors spin on startup, the lights flash correctly, the sound is normal, and the gimbal performs a check.
The firmware is up to date.
I reset the radio control.
Has anyone had this same problem and could help me?

 

[Cafguy]

y DJI AIR 3S won't start when I tap RC2 on the screen or through stickers.

The air 3S wont simply start with a tap you must follow a certain button sequence.
Press and release the power button once, located towards the rear of the Air 3S.
Immediately press and hold the power button for two seconds. You'll hear an ascending audible tone when it powers on

 

[FlyCeara]

The air 3S wont simply start with a tap you must follow a certain button sequence.
Press and release the power button once, located towards the rear of the Air 3S.
Immediately press and hold the power button for two seconds. You'll hear an ascending audible tone when it powers on

DEAR FRIEND,
I appreciate your time in helping me, but you didn't understand what I meant.
I went through the entire process of connecting the drone and the RC controller.
When I was authorized to take off, the drone didn't start the propellers.
No error message appeared on the screen, and I updated all the firmware.
Thank you for your attention.

 

[waynorth]

Did your drone work fine before you updated the firmware?

 

[FlyCeara]

Seu drone funcionava bem antes de você atualizar o firmware?

YES