when i turned on my RC controller after returning home from a days flying, i was greeted with a message about a firmware update for the RC ,so after downloading it,and installing ,on switching off the controller and then back on again, i was prompted to download firmware for the drone ,this requires the drone to be powered up ,then when its all been installed ,the drone will shut itself off, and then you have to turn it on again for it to be finalised
the only difference i have noticed so far is before the update in safety settings the chosen setting for metric or imperial ect on the screen readouts for distance , hight , speed, needed setting each time the controller was turned on or off ,since the update ,my preferred setting imperial stays locked on
the only difference i have noticed so far is before the update in safety settings the chosen setting for metric or imperial ect on the screen readouts for distance , hight , speed, needed setting each time the controller was turned on or off ,since the update ,my preferred setting imperial stays locked on