GIMBAL

[kingbrad22]

What yall think

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[Jenee]

Is the gimbal seated correctly. It should be underneath the front and rear tabs. Just sounds like it is not in the correct position and that is causing the knocking noise.

 

[kingbrad22]

Is the gimbal seated correctly. It should be underneath the front and rear tabs. Just sounds like it is not in the correct position and that is causing the knocking noise.

It looks right to me but...

 

[Jenee]

It looks right to me but...

Have a look at the start of this video which shows what you need to check on the gimbal.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[kingbrad22]

Figured it out partially. The knocking noise is the gimbal swinging to fast

 

[SoapyGolem]

It isn't supposed to be doing that, try doing a gimbal calibration... if that doesn't help then return it

 

[n0gga]

seems to me that the gimbal is performing the startup procedure like it did on earlier firmwares.
Believe that the .500 included optimized gimbal calibration that slowed down this procedure.

What firmware are you running?

 

[kingbrad22]

It isn't supposed to be doing that, try doing a gimbal calibration... if that doesn't help then return it

Tried it. It started working properly. Everything was good. Reset the drone and it started the knocking again

 

[kingbrad22]

seems to me that the gimbal is performing the startup procedure like it did on earlier firmwares.
Believe that the .500 included optimized gimbal calibration that slowed down this procedure.

What firmware are you running?

The newest one, .600 i think it is