HELP Mavic 2 Pro Gimble Overload Warning and camera locks tilted

[PatrickMicc]

Mavic 2 Pro HELP Gimble Overload Warning and camera locks tilted. Has happened a few times, usually when shooting a quick POV, even shooting a manual POV. It gets stuck tilted and so far after landing and DOING A gimble calibration and shutting down it straitens up. I will look for and show footage of this next. ANY HELP would be appreciated, don't really want TO SHIP IT BAKC FOR REPAIR JUST YET. thanks

 

[adcimagery]

Got any grit in the motors? Might be that one is binding up.

 

[PatrickMicc]

Got any grit in the motors? Might be that one is binding up.

THANKS, but no, i did check for that, twice I ran calibrate and it froze at 20 % then after fiddling with it got through the calibration, here is the shot, last time it happened.


DJI_0717.MP4

 

[adcimagery]

If it's failing out on calibration, I'm not sure there's anything you can do, unfortunately. Sounds like a repair issue then. Good luck!

 

[PatrickMicc]

If it's failing out on calibration, I'm not sure there's anything you can do, unfortunately. Sounds like a repair issue then. Good luck!

The Firmware REFRESH from the dji assistant worked, tried POV at 16mph with a reverse direction and no error THANKS to you and dji !

SamsClubPOV.mp4