Importing Litichi Waypoint Missions into DJI Fly App

[TexasStar15]

I’m flying a DJI Air 3S and have created a waypoint mission in Litichi Hub. I have tried and tried to import it into the DJI RC2 controller with no luck. I Rename the KMZ file exported by the Litchi Hub to the same name as the KMZ created by DJI Fly. Then replace the DJI KMZ with the Litchi Hub KMZ. When I go back into the waypoint missions on the controller it’s not there. The mission I created with 2 waypoints is still there. Could anyone please explain to me why this is happening? I’ve done it 10 times with the same results. Is this even possible with the Air 3S, I watched video's and read articles that it was but I haven't had any luck yet. Thanks guys!

 

[GadgetGuy]

Sounds like you aren’t properly overwriting the original waypoint file with the new one in the correct location. If done properly, the original waypoint file no longer exists.

 

[TexasStar15]

Sounds like you aren’t properly overwriting the original waypoint file with the new one in the correct location. If done properly, the original waypoint file no longer exists.

Thanks, I'm going to try again today, I'll let you know the results.

 

[Rolandmavic]

Is this possible? I bought an air2 s because it is fully supported by litchi.
Roland

 

[DJ Wes]

Is this possible? I bought an air2 s because it is fully supported by litchi.

If you are asking if a Litchi waypoint mission can be converted and loaded into DJI Fly, the answer is "yes". The conversion software and instructions are available on this site:

Litchi Mission Utilities

Wes Barris

www.litchiutilities.com