- Joined
- Oct 30, 2018
- Messages
- 3
- Reactions
- 0
- Age
- 40
Ok so I know this has been covered a few times - i did search a lot first.
But I just cannot get my lens bezel off of my new Mavic Air so that I can put a filter on.
Does anyone have any suggestions not covered below.
Rubber band.
Using three fingers for even distribution of pressure.
Using flat usb chord as make shift wrench.
Using a hairdryer (didn't actually try this, doesn't seem too smart?).
Pushing in while twisting.
Any combination of all of these.
I really need to get this filter on for a job I should shoot tomorrow (I could shoot the drone footage the next day but not preferable) and since I live in Bali, Indonesia, there is no authorized repairer etc where I can even take the drone to get it done.
Please please help!
But I just cannot get my lens bezel off of my new Mavic Air so that I can put a filter on.
Does anyone have any suggestions not covered below.
Rubber band.
Using three fingers for even distribution of pressure.
Using flat usb chord as make shift wrench.
Using a hairdryer (didn't actually try this, doesn't seem too smart?).
Pushing in while twisting.
Any combination of all of these.
I really need to get this filter on for a job I should shoot tomorrow (I could shoot the drone footage the next day but not preferable) and since I live in Bali, Indonesia, there is no authorized repairer etc where I can even take the drone to get it done.
Please please help!