I was out today trying my first flight with Litchi. I set up a simple 5 waypoint flight with 2 POIs. All routing was done straight, at least as far as I could tell. There were none of the blue curve arcs visible. I started the mission, the M2P lifted off and went to WP1, where I had an action to turn on recording. It did so, then flew on normally to WP2, WP3 and WP4. WP4 had four actions - Stay for 3s, Stop Recording, Take a Photo and Start Recording. It did the first three. I did not notice this during the flight as I was switching between watching the drone and the Go4 displays. It tracked properly to WP5, interpolating the gimbal down as I asked it to, then returned home and landed fine.
Anyone have any thoughts on why it wouldn't have started recording at WP4. I took off again right after that for a short hop and when I went to start the video recording, it was still in Photo mode, so it's pretty clear it never ran the Start Recording command.
I'm planning to use Litchi tomorrow to do a fun little survey flight around a friends property and I have a ton of Stop/Starts set up already so I'd sure like to get them working.
Thanks in advance for any advice!
Anyone have any thoughts on why it wouldn't have started recording at WP4. I took off again right after that for a short hop and when I went to start the video recording, it was still in Photo mode, so it's pretty clear it never ran the Start Recording command.
I'm planning to use Litchi tomorrow to do a fun little survey flight around a friends property and I have a ton of Stop/Starts set up already so I'd sure like to get them working.
Thanks in advance for any advice!