Litchi Mission Photo Help

[nedcampbell]

This is my Litchi mission. It is all at the same height around a construction site point. What I don't understand is that around some points it stays set video at the 10 AGL centerpoint, but at other point the video shoots higher so I am having to manually point the gimball down -- it results in a very erratic video. Is there a setting I am missing somewhere to get a smooth video shoot?

 

[dfb]

The video might help, but the waypoints around the poi are at different altitudes. Looks like 60 to 108 feet. Check that each waypoint looks at poi 1, they might not.

 

[dfb]

PS if that did not make sense, each waypoint has Gimbal Pitch: disabled focus poi interpolate, & an angle degree. Pick focus poi.

 

[nedcampbell]

All the WOs are at 200 AGL. There is only POI and they all point to it. At least that’s what I think. Am I looking at this wrong? I’m a total Litchi newbie.

 

[nedcampbell]

I had Focus POI selected and then it jerked at every corner. When I put Interpolate on it smoothed out the corners nicely. But now I have this other effect.

 

[nedcampbell]

I had Focus POI selected and then it jerked at every corner. When I put Interpolate on it smoothed out the corners nicely. But now I have this other effect.

 

[dfb]

 

[dfb]

Can't see the video but there is another problem with the Mavic2. I jitters or jumps on waypoint turns. It has not been fixed that I know of. That might be your problem.

 

[dfb]

Can Someone Figure out Why Mavic 2 'Waypoint' PANS are AWAYS JERKY???

Good question. I just flew a test with manual heading control. It was just as jerky either way. That would seem to suggest a "ratcheting" in the yaw motion of the craft rather than a gimbal anomaly.

mavicpilots.com

see if this is what you're seeing.

 

[nedcampbell]

I created new flight plans using Focus POI and will be testing them out again!

 

[Berche]

[QUOTE = "nedcampbell, post: 780735, member: 74414"]
Ceci est ma mission Litchi. Tout se trouve à la même hauteur autour d'un point de chantier. Ce que je ne comprends pas, c’est que, sur certains points, la vidéo reste configurée au centre de la 10e AGL, mais à un autre moment, la vidéo monte plus haut et je dois donc pointer manuellement la manette vers le bas. Il en résulte une vidéo très erratique. Y a-t-il un paramètre qui me manque quelque part pour obtenir une séance vidéo fluide?View attachment 76895
[/CITATION]Je pense que dans ce cas le Mode Orbit sur le téléphone serait plus approprié

This is my Litchi mission. It is all at the same height around a construction site point. What I don't understand is that around some points it stays set video at the 10 AGL centerpoint, but at other point the video shoots higher so I am having to manually point the gimball down -- it results in a very erratic video. Is there a setting I am missing somewhere to get a smooth video shoot?View attachment 76895

Je pense que ce sera le mode Orbit sur le téléphone serait plus approprié