Asking for help:
New behavior for stock older drone (Mavic 2 Pro) (latest FW, latest FC, latest Go4 on Smart Controller - reflashed firmware, same behavior)
I fly to inspect avalanche fences, forrest health, potential rockslides/avalanche and mountain construction sites for agencies in the italian alps. One drone I use is the M2P. Altitude and location can be several KM from home point and several KM in altitude, though rarely more than 50m AGL during flight (steep mountain incline)
It may be coincidental, but I just got MAS Endure props (i've been using stock and MAS Stealth props for hundreds of flights, no issue). Also have a new battery (6 months), which until now has been fine. Again, this may be coincidental.
The new behavior is an "Extra Payload Detected" message appearing - usually when the drone is near the mountain peak. I've occasionally seen the 'High Winds" message, but I try not to fly in those conditions.
The Payload message triggers a throttling of performance. Ascent & descent are capped at 3m/s and horizontal speed is capped at 30km/h. I have changed the sport mode parameters to be higher, but these settings are ignored.
I'm not able to understand the DAT/TXT files enough to understand exactly what is going on. I see battery errors around the time the message appears.
354.907 : 20227 [L-NS][AHRS] Bad sample tick measure or recapture signal: 0.005000
362.393 : 20602 [L-BATTERY]get cell voltage time out!
589.663 : 31989 [L-BATTERY]flylog_data_report_prepare error, ret1=0,ret2=-6,ret3=0
Now, the older battery and original props are also triggering this Warning/error and performance throttling.
Where can i look to see what's triggering this error and correct whatever is causing it. Being able to move quickly at these distances and altitudes is critical for safetly.
New behavior for stock older drone (Mavic 2 Pro) (latest FW, latest FC, latest Go4 on Smart Controller - reflashed firmware, same behavior)
I fly to inspect avalanche fences, forrest health, potential rockslides/avalanche and mountain construction sites for agencies in the italian alps. One drone I use is the M2P. Altitude and location can be several KM from home point and several KM in altitude, though rarely more than 50m AGL during flight (steep mountain incline)
It may be coincidental, but I just got MAS Endure props (i've been using stock and MAS Stealth props for hundreds of flights, no issue). Also have a new battery (6 months), which until now has been fine. Again, this may be coincidental.
The new behavior is an "Extra Payload Detected" message appearing - usually when the drone is near the mountain peak. I've occasionally seen the 'High Winds" message, but I try not to fly in those conditions.
The Payload message triggers a throttling of performance. Ascent & descent are capped at 3m/s and horizontal speed is capped at 30km/h. I have changed the sport mode parameters to be higher, but these settings are ignored.
I'm not able to understand the DAT/TXT files enough to understand exactly what is going on. I see battery errors around the time the message appears.
354.907 : 20227 [L-NS][AHRS] Bad sample tick measure or recapture signal: 0.005000
362.393 : 20602 [L-BATTERY]get cell voltage time out!
589.663 : 31989 [L-BATTERY]flylog_data_report_prepare error, ret1=0,ret2=-6,ret3=0
Now, the older battery and original props are also triggering this Warning/error and performance throttling.
Where can i look to see what's triggering this error and correct whatever is causing it. Being able to move quickly at these distances and altitudes is critical for safetly.