Mavic Air, Gimbal motor overloaded

[#pusicinacestach]

Hello guys, after crash i fixed the broken arm, but can not figure out how to fix my gimbal.
It says overloaded gimbal motor.
The camera is in the angle .
Any suggestions?
Thanks

 

[Former Member]

Are you getting video feed? It could either be your gimbal ribbon cable and/or a bad gimbal motor.

 

[#pusicinacestach]

Yes i am getting everything, it is just showing gimbal motor overloaded and the camera is in angle

 

[Former Member]

You might have a bent yaw arm on your gimbal. Have you tried to adjust the gimbal roll in DJI Go 4?

 

[#pusicinacestach]

You might have a bent yaw arm on your gimbal. Have you tried to adjust the gimbal roll in DJI Go 4?

Yes, not helping

 

[Former Member]

With the power off, take some pictures of your gimbal from the front. I think the yaw or pitch arms are bent.

 

[#pusicinacestach]

With the power off, take some pictures of your gimbal from the front. I think the yaw or pitch arms are bent.

Everything looks fine

 

[Former Member]

Can you power it on and take some more pictures?

 

[Mike_Flys]

Yes i am getting everything, it is just showing gimbal motor overloaded and the camera is in angleView attachment 40737

Mine is doing the same thing. Nothing seems to fix it.
Also my front vision sensors are out. Mine wasn't crashed.

 

[#pusicinacestach]

Can you power it on and take some more pictures?

 

[#pusicinacestach]

Mine is doing the same thing. Nothing seems to fix it.
Also my front vision sensors are out. Mine wasn't crashed.

My vision sensors are ok just the camera in angle

 

[#pusicinacestach]

View attachment 40741View attachment 40742

Also when i am trying to do gimbal calibration it is always stuck on 10%

 

[Former Member]

My vision sensors are ok just the camera in angle

When you took it apart to replace the arm, did you move the gimbal? It looks like it is not installed correctly. The gimbal should be horizontal to the ground when it is turned on.

 

[#pusicinacestach]

I fixed the arm with the superglue.
I bought a new arm, but do not have that small screwdriver so fixed with superglue and ordered set of screwdrives. So the answer is no i did not move it [emoji23]

 

[Former Member]

Something is broken on your gimbal. You will need to take it apart or have a repair shop look at it.

 

[Former Member]

Mine is doing the same thing. Nothing seems to fix it.
Also my front vision sensors are out. Mine wasn't crashed.

You might try rolling your firmware back 1 version and see if that helps. Was yours ever working correctly?

 

[#pusicinacestach]

You might try rolling your firmware back 1 version and see if that helps. Was yours ever working correctly?

did not help at all

 

[#pusicinacestach]

Something is broken on your gimbal. You will need to take it apart or have a repair shop look at it.

I was afraid of this

 

[Former Member]

did not help at all

I was actually relying to the other post. Yours is going to need to be sent in for repair.

 

[#pusicinacestach]

did not help at all

and yes it was working fine