Mavic Pro - Gimbal motor overload even after changing ribbon and gimbal arm

[Wanbli]

Hi, I am having a similar issue. Tried 2 different ribbon cables, camera works but gimbal is still showing motor overload. I really need to fix it. Did you ever find a solution?

I would rather not have to buy the arm structure, but I will if anyone can confirm that to be a fix.

Thanks a lot.

Buy the arm structure, about $45 on ebay. I don't mess with the ribbon cables anymore, there's too many people flying these on the beach or in the dirt and you can NEVER get all that crap out of those little motors. Gimbal Camera Arm Motor with Flexible Flat Ribbon Flex Cable for DJI Mavic Pro | eBay

 

[Wanbli]

View attachment 98176. I get these warnings

If you get those warnings after replacing the gimbal arm, you got a bad one. I repair the M1P's and about 1/3 of the arms I buy are defective and I send them back for replacement or refund. I also buy the arm WITH the ribbon cable installed. The ribbon cable is a PiA to install and get right! Gimbal Camera Arm Motor with Flexible Flat Ribbon Flex Cable for DJI Mavic Pro | eBay