I crashed my Mini 3 Pro after it drifted into the side of a building. I assume it was because of bad GPS reception as I only had 5 satellites at the time. Nonetheless, after the crash the live feed stopped working, and the last image on the RC was a bunch of lines. It also threw an Incompatble Gimbal IMU Data error. From reading through forums and google, the suggested problem was a bad camera module, so I ordered a replacement. The camera arrived today and as I powered up the drone after sitting for about a month, a Gimbal Stuck error now appeared and the gimbal does not power up anymore. It still has the same camera issues so I replaced it anyway. After replacing the camera I still have no live feed and nothing happens when I press record. Camera S/N also does not show up. Could the signal cable for the camera and gimbal be bad at this point?
Firmware version: 01.00.0500
Attached below is the errors that pop up in DJI Fly:
Firmware version: 01.00.0500
Attached below is the errors that pop up in DJI Fly: