Got my air 2 a few days ago.
Activation and pairing to my RC and Fly app (android) with location spoofed to US.
Updated AC firmware with dji assistant.
Went for first few flights with 2 batteries....here comes to rebellion:
1. My aircraft is usually with "FCC on", even though I dont start the motors before launching fly app. After power off and cycle, FCC mode seems to be still On.
2. My AC is flying above 120m in unlocked Geozone. to my surprise it just follows the altitude limit in the app, which i can set at anything below 500m. For a brief 2 minutes I felt like transforming from a tiny butterfly to an eagle. For this I'd like your pardon NOT to offer proof whatsoever for obvious reasons. I assure you it was not intentional and i got down quite soon and may never (not) do this again. No, I will not try in a no fly zone. I suspect it won't lift off. I will also not fly into the nfz.
I dont think I'm going to update the firmware unless there is a ground breaking feature or crippling bug.
Activation and pairing to my RC and Fly app (android) with location spoofed to US.
Updated AC firmware with dji assistant.
Went for first few flights with 2 batteries....here comes to rebellion:
1. My aircraft is usually with "FCC on", even though I dont start the motors before launching fly app. After power off and cycle, FCC mode seems to be still On.
2. My AC is flying above 120m in unlocked Geozone. to my surprise it just follows the altitude limit in the app, which i can set at anything below 500m. For a brief 2 minutes I felt like transforming from a tiny butterfly to an eagle. For this I'd like your pardon NOT to offer proof whatsoever for obvious reasons. I assure you it was not intentional and i got down quite soon and may never (not) do this again. No, I will not try in a no fly zone. I suspect it won't lift off. I will also not fly into the nfz.
I dont think I'm going to update the firmware unless there is a ground breaking feature or crippling bug.
