When I went to fly my Air 2s with the RC Pro today a message appeared on the main screen that RC calibration was required. I turned off the drone (as requested) and went to control and then to RC and did the calibration with each stick - moving them around to the edge - the graphic on the screen showed 100% at each extreme and all the way around. I moved them several times in all directions. There was no notice that it was successful (the inside graphic didn't change) and when I closed the screen, went back to fly, and turned on the drone, the same message appeared. I did this four or five times with no success. I would appreciate advice on how to fix and complete the calibration. I have attached several photos. the 100% green showed at every point as I rotated the sticks around. Thanks so much.