After considering very carefully purchasing an AIR 1 (due to excellent reduced prices at present due to clearance of the old model) for some time I have now decided to spend more and get the AIR2.
I have started researching youtube videos and wondered about the following -
There doesn't seem to be prop guards with either the 'standalone' or the flymore combo. As a relatively new drone user (I have a cheap toy grade drone) that worries me BUT I cannot find anywhere they might be available even as an 'after market' item.
Spare props. I can only find listed on Ebay NON genuine props listed (and I have read bad comments about non genuine props) and could not find them listed on the DJI web site. Where are they available from?
Lastly the manual (I pre-downloaded it to read) states the maximum size for mobile/cell phone at 180x86x10mm.
I could see in videos that there appears to be no restrictions on the width unlike the AIR1 which holds the phone by the sides BUT is the width really restricted to a maximum of 86mm as the part which holds the top of the phone appears to pull out (to allow the phoen to be inserted) a lot more than the phone which was used. I was just wondering if a small tablet (7" or 8") might fit.
Thanks
John
I have started researching youtube videos and wondered about the following -
There doesn't seem to be prop guards with either the 'standalone' or the flymore combo. As a relatively new drone user (I have a cheap toy grade drone) that worries me BUT I cannot find anywhere they might be available even as an 'after market' item.
Spare props. I can only find listed on Ebay NON genuine props listed (and I have read bad comments about non genuine props) and could not find them listed on the DJI web site. Where are they available from?
Lastly the manual (I pre-downloaded it to read) states the maximum size for mobile/cell phone at 180x86x10mm.
I could see in videos that there appears to be no restrictions on the width unlike the AIR1 which holds the phone by the sides BUT is the width really restricted to a maximum of 86mm as the part which holds the top of the phone appears to pull out (to allow the phoen to be inserted) a lot more than the phone which was used. I was just wondering if a small tablet (7" or 8") might fit.
Thanks
John
Last edited: