New here foks and like many others I was tired of having to take off the two guards for the camera and gimbal so I piurchsed the Three Kings all in one uint.
I am having a little problem, there is a small round tab on the back side of the gimbal that is held on by two small screws that is starting to bend and have small cracks on each side. I am believing the the two little flat fingers inside the cover of the gimbal guard are to long and are putting pressure on this small tab. Has anyone else experienced this and have you had to grind a little off those two tabs?
Can someone tell me the purpose of this little tab on the back side of the gimbal, is it to protect the ribbon/wire on the backside of the gimbal? I have attached a picture of the small tab on the backside of my gimbal and how it is bent.
Greatly appreciate any wisdom and input from you folks, thank you.
I am having a little problem, there is a small round tab on the back side of the gimbal that is held on by two small screws that is starting to bend and have small cracks on each side. I am believing the the two little flat fingers inside the cover of the gimbal guard are to long and are putting pressure on this small tab. Has anyone else experienced this and have you had to grind a little off those two tabs?
Can someone tell me the purpose of this little tab on the back side of the gimbal, is it to protect the ribbon/wire on the backside of the gimbal? I have attached a picture of the small tab on the backside of my gimbal and how it is bent.
Greatly appreciate any wisdom and input from you folks, thank you.
