Trying to figure out dji assistant 2. I get through the updating firmware bother, then try to calibrate. It tells me it can't tell what size my monitor is, so I input 42 (not knowing if that is what they are asking, but it's the size of my monitor), then I click on "Recalibrate". The window opens, on the left side of the pane are the instructions how to hold the drone, etc. At the bottom of that pane are two boxes labelled "sensor status". On the extreme right of the window are three buttons, one with a question mark indicating "help" (not really helping) which, if you click on it brings up 4 possible help subjects that don't help at all, then a button which starts the tutorial, then a third which expands or shrinks the entire window.
In between is a large blank area where you actually do the calibrating. At the end of the tutorial there are two buttons -- one says "previous" the other says "calibration" -- they both are greyed out and do nothing. There is no other button to start the calibration, no indicator as to what's next. Basically this is as far as I have gotten -- I hold the drone up as the tutorial tells you to -- then NOTHING happens. WTF am I doing wrong?
Please help -- also remember that I am very stupid and don't understand everything I find on DJI's horrible software and firmware.
In between is a large blank area where you actually do the calibrating. At the end of the tutorial there are two buttons -- one says "previous" the other says "calibration" -- they both are greyed out and do nothing. There is no other button to start the calibration, no indicator as to what's next. Basically this is as far as I have gotten -- I hold the drone up as the tutorial tells you to -- then NOTHING happens. WTF am I doing wrong?
Please help -- also remember that I am very stupid and don't understand everything I find on DJI's horrible software and firmware.