After crashing my Air 3 and losing gimbal signal and control I've seen found and replaced a broken gimbal ribbon cable and flex cable. Initially with the new ribbon only I had control of the gimbal but no signal.
Now with both new cables I have no control and no video. Whenever I try to calibrate the gimbal through the controller it says 'ensure aircraft connection is normal and retry'. What does this mean?
The aircraft is definitely connecting to the controller, and it will take off if I tell it to. I can calibrate my compass and IMU no problem but cannot do anything with the gimbal.
Does anyone have any advice??
Now with both new cables I have no control and no video. Whenever I try to calibrate the gimbal through the controller it says 'ensure aircraft connection is normal and retry'. What does this mean?
The aircraft is definitely connecting to the controller, and it will take off if I tell it to. I can calibrate my compass and IMU no problem but cannot do anything with the gimbal.
Does anyone have any advice??