I just got my Mavic Pro from Harvey Norman, Mt Barker, and when calibrating my gimbal it seems to stop and struggle around the 71 - 73% mark. Has anyone else come across this? I can't seem to find anything across other forums.
Redo IMU and make sure the unit is cold.I just got my Mavic Pro from Harvey Norman, Mt Barker, and when calibrating my gimbal it seems to stop and struggle around the 71 - 73% mark. Has anyone else come across this? I can't seem to find anything across other forums.
Yeah, I read up on a couple of forums and ended up downgrading the firmware to 1.2.9 Problem solved.I am getting the same error, stops at 73% all the time, did you get this fixed? I have no problems with the gimbal though, just try to calibrated to make sure.
Yeah, I read up on a couple of forums and ended up downgrading the firmware to 1.2.9 Problem solved.
I would rather not risk it until I know that the problem has been fixed. Not knowing there was a problem in the first place freaked me out when I first tried to calibrate it.DJI send a tweet today about a new firmware, maybe that is corrected there, maybe.
What round plastic protection over the sensors you refer to?Almost embarrassed to suggest this but I assume you've taken the gimbal dome cover off and also the gimbal clamp? Also taken off the round plastic protection over the sensors?
I just got my Mavic Pro from Harvey Norman, Mt Barker, and when calibrating my gimbal it seems to stop and struggle around the 71 - 73% mark. Has anyone else come across this? I can't seem to find anything across other forums.