I have found this forum to be super helpful to understand challenges and successes other have experienced. With that... today I experienced an unexpected crash at a low altitude; about 3' off the ground. I had been out flying around my property without incident. I was out along the local street flying at a lower altitude and when I was flying my MP back towards me I throttled up (altitude) to fly up and over me standing in the street. I had done this once before with success. This time was different. I push the left controller up to gain altitude and to my surprise the drone flipped and crashed into the street. Upon impact the battery dislodged from the aircraft laying beside my MP. Upon inspection the nose suffered damage causing the case to separate a bit. There is also a couple of marks on the area around the lense of the gimble where it impacted the street. When I placed the battery back in the MP and fired it up I connected with the ability to see through the gimble on my iPhone but it started throwing an error code: a00008 Forward Right Vision Sensor Error and Vision System Error. Upon restarting the MP the gimble does not go through the normal startup checks; it simply just sits there. Another error message that I received indicated Aircraft Motor Overloaded. Any thoughts would be appreciated. Thanks everyone.