Recent content by AirScooter

Has this been brought to your attention before? I searched for it but didn't see it so I thought I would put it out there. I have a HP Pro Elitebook that has a HDMI out and a pair of Yuneec Skyview's. I have really never been able to line up a decent connection for FPV until I discover a Samsung...

Thank you DanMan … funny you should say that. I've tried every twisted way I can think of. Only a man as ignorant as I am can come up with the routes I have tried while laboring to link this lovely old bird. I did finally determine that the controller and the aircraft are on the same Firmware...

Hey Folks, I purchased a pretty screwed up old Mavic Pro for what I could afford with the intentions of bringing it back to life. I replace the upper board as the number 2 ESC was toasted, put a new set of front facing sensors in it, the left one wasn't there and this week I replaced the flex...

Sorry for the delay with my reply. Thank you. This will be a new drone controller connection. So I will use the Link button for the initial binding.Thanks again. AirScooter Winston-Salem NC

As a very new pilot I am confused about the use of the "Linking Button". I am watch the tutorials and it seems whenever there is a binding process going on between the RC Controller and the Craft the linking button is being pushed. Am I interpreting that instruction correctly or is the...

This $100.00 Mavic Pro basket case that everybody told me was toofar gone to resurect took to the air last night like a spring chicken. Actually it flew a great deal better that a chicken. So now I've worked my way through all the current problems having avoided the elephant in the room. Now I...

The ESC board in my basket case MP was diagnosed with a toasted ESC and after trying to find the parts, I finally broke down and bought a new board. The old board is out and the new board is sitting on my desk for installation tonight. During the removal, I read a "Thread" describing the...

Anyone remember seeing what the antenna in the left front leg (Mavic Pro) looks like? I have one that I have to put back together. It separated from the plastic piece that slides down the leg. They do connect together, don't they? Thanks, AS

Thanks for the information. I know now you are correct

I would like to diassemble my gimbal and inspect and clean it.(Mav Pro) Anyone know of a good vid that would instruct me. Most of what is on YouTube has to do with the flex cable. Thanks AS

RFM, Here is the follow through I promised last week, which feels to me like a month of Sundays. I have been living with this drones electronics night and day and have finally come to the conclusion that if I could buy a board cheap enough I would. I found one last night, $68 USD, and it will...

Very good reply RFM, I'm going to try it, but before I do, I'm wondering what the reporting screen would indicate if one of the ESC's were dead? If I could prove to myself that one was dead then I would start cutting back on dog food. This old mutt needs to go on a diet anyway. Thanks RFM great...

I have a Mavic Pro that has as part of it's complaints the "ESC Status Unknown" error. I have the leg and motor off and over to a buddy's place who has a variable output power source. His goal is to determine if the motor seems like it is running and excepting inputs as it should. I have...

I want to run the ESC software on Assistant 2 for my Mavic. Does anyone know what the ESC's are on the 2018 Mavic Pro. Thanks AirScooter

My primary laptop is a Chromebook. I know that horrifies some people but it was either give my last Windows machine away or check into the nearest nut lodge. Can I update the firmware in my MP through it? and .... Is the gimbal overload always a bound gimbal of some sort. I started ownership of...