Recent content by aneal321

Fantastic! Great job. I don't know if I have the patience for that, or the drawing ability, but I love what you've done.

I didn't know that you could get an SSD in 2013. But time does fly, doesn't it. I would have guessed first available around 2017. Glad you are having success and long life from your Macs

I have read some other threads about processor chip overheating but not quite like mine. The fans comes on and runs for about 10 seconds then shuts off. I connected to DJI Assistant and the fan ran for quite awhile. Went back outside to try again and the fan ran for an extended time but the...

What apps do people use to do the tracking. Will it show the location of the drone or the location of the controller, or both? I thought I saw an article recently about updating (extending) VLOS in US. I will have to look for that.

Thanks for that information, lookout. Good to know. Maybe one day they will make our lives easier.

Below is a photo of my display as I turned on some RID settings yesterday. It is time to renew registration with FAA and it asked the question if my drone broadcasts an ID. I didn't think that was in the cards yet, but it does show an ID, with no flight information as I was hovering. Does...

Michigan City here. Welcome to the club.

I thought about other objects too. I launched from the ground and stepped away from a bench that was nearby, other than that, just soil and water nearby.

yes, my mistake. I don't have any of that in front of me.

Yesterday I was going to do some recreational flying M2Pro in an area where I've flown 5 or 6 times before. There are some high intensity power lines a few hundred feet from where I was launching. Two unusual things happened, I believe unrelated to each other. B4U Fly gave me a message to...

Thank you for taking the time to provide this excellent response and phots. I remember watching a video some time ago about repairing or replacing camera mount on gimble. It seemed fairly involved and I wasn't sure I wanted to delve that deeply because it is working and only needs occasional...

it seems to move into the arm. I was hoping it would "snap" back into place, but it doesn't. It returns to a position similar to the photo, not quite as pronounce. That photo was taken very soon after the crash I soon as I noticed the gap.

not in fpv mode the gap is not quite as wide as in the attached photo, I pushed it in a bit but it won't go further. I have not performed a gimble calibration in a while and I don't think I have done one since the crash. Thanks for your response.

thanks to all of you for providing such informative information.

Hello all: My Mavic 2 Pro I have noticed if I hover and rotate left or right, the gimble gradually shows horizon tilted. I can readjust it during flight but it reoccurs if I continue rotating. I haven't noticed any other issues while flying or filming. No tilt up and down issues, does not...