Recent content by bymoerch

Sure thing, I have 3 decimals.

I have full coordinates on my MM photos :)

You can fly it manually and find somewhere online to stich the map together. It's not impossible. I did it with webODM. Just make sure to get clear pictures.

Good stuff :) I tried with copper tubing around my antennas, one at a time and both of them, got full signal all the way, hehe. Havn't tried with some distance. I'll do some tests as soon as i have mounted RMA så i can disconnected the antennas.

That would make sense. The question then is wether it's like the Pro, or if both of them sends and receives.

Hello everyone. I have searched around a lot, but doesn't seem to be able to get a straight answer. I'm trying to figure out the antenna configuration on the mavic mini RC. On the mavic pro, left antenna is TX/RX and right antenna is RX only. That makes it possible to just boost the left...

Any luck on this information? I asked one forum, and they said it was one 2.4 and one 5.8 antenna on the RC. Not confirmed tho.

Guys, this table if from the official documents. The class C2 is basically the same as C1. Online training and test. The only difference is that you cant fly over uninvolved people, unless you get a certified training certificate. So relex everyone, it's not like the 2 pro is going to be...

I must admit, I love my little mini and are looking for a used mavic pro as well already. I understand why all the threads about lost drones can be a bit frustrating. But for me it really made me improve my knowledge about flying conditions and the mini. I'm sure the reason I'm not (hopefully)...

Lovely setup, I'm looking to do something like it. But I dont have any Yx cables, so will have to make something.. Do you know if i need to parallel connect to both +/- outputs, or can i use just one of them?

Sure thing, I have attached a picture. :) It doesn't come with an adaptor, so I need to put something together. But i dont know wether I just need to drain from one set of the +/- or I need to do both of them in a parallel connection. I would to prefer to fly, until half empty, butI live...

Quick question. Did you just connect to discharger to all the cells in a parallel connection? Im planning to make a discharger for my MM

I bough a discharger :) Do you guys know wether I just nee to connect the discharger to the 2 pos/neg ports, and then it should be good to go?

I'm just hoping we find a way to fix it :D