Recent content by Faodave

Camera reset did the job thanks. Odd one though.

I got a Mavic Pro 2 recently, upgraded the firmware via assistant 2 and everything was fine. At some point after that Go4 indicated that some modules had incompatible firmware so I let it rectify the issue. I can't say that it was the point that it all went bad for sure but it has major image...

You and I are not going to see eye to eye on this one, It is my opinion that you are wrong. This happened on a nature trail, far from power lines, microwave ovens and wifi. Simple fact of the matter is that given they advertise and purport up to 7km range you would not expect it to lose...

And, WHY did it lose connection - that is the point. I did not turn off the RC!

What a stupid thing to say, you tell me where it says you might lose connection at 15m?

Rubbish. Simple fact is that it lost connection with the controller when it shouldn't have, end of story.

It's a beautiful bamboo arch, but if the mavic didn't lose connection it wouldn't have triggered the rth

Such as?

But even from their description they are admitting that the Mavic lost contact with the controller no?

My Mavic decided to do a RTH crashed into a branch and consequently the concrete damaging it considerably. Mavic was 15m from controller and DJI confirmed it did a RTH because it lost contact with the controller. They are saying it was my fault as below: Non warranty per data analysis; RTH...