Recent content by geekone

That was. Solved now

Back in flight

But .. it looks like it wasn’t the engine… After a longer flight today the new engine heated up as well and the app showed ESC connection error 30085. I found in a previous thread that it can bea caused by bad soldering or by a broken ESC board. I’m not especially good in soldering so, even...

But .. it looks like it wasn’t the engine… After a longer flight today the new engine heated up as well and the app showed ESC connection error 30085. I found in a previous thread that it can bea caused by bad soldering or by a broken ESC board. I’m not especially good in soldering so, even...

Just scratched it off with a screwdriver

Almost 2 years later, I did the same mistakes while soldering front arm wires on my Air 2S' ESC, which lead to the same ESC error 30085. How did you fix it in the end?

Finished, front arm replaced! First test flight looked good, tomorrow more extensive tests. 5 hours work, but funny.

Finished, front arm replaced! First test flight looked good, tomorrow more extensive tests. 5 hours work, but funny.

Hey BSauce955, the front cover went away. A little help for the top cover? I moved the battery screws, the six bottom shell screw, the two front screws under the front plastic nose and the two, littler, screen at the bottom back of it. Still the top cover doesn't pop up, the back of it still is...

Good question 😕

Thank you BSauce955

I already removed the gimbal and popped the two upper clips. Are there more clips? On the sides? Under the bottom seam?

I’m tearing down my Air2S in order to replace right front arm and engines. There aren't many tutorials out there, I’m currently stuck at removing front plastic cover, the one protecting the front sensors. Any help/hint?

Yep warranty’s over, so no prob. I didn’t know, I was very surprised when I saw it 😂

It was just a kind of sealing !