-Motors are 2312 960kv
-Not factory wiring. I’ve opened the bottom of the arms and made a space for the new cables. The idea was to pull them free in both directions.
-I shortened the props 6mm each side and balanced them.
-The adaptors are made of coins and I use only three holes of the motors...
I am runing 01.03.0400 flashed with No Limit Dronez tool. I have NFZ and Altitude removed, Normal+ and Sport ++ mode.
After missing the success this morning with Phantom motor I upgraded to original 01.04.0300 FW. I’ve cut the wires about 1 cm and resolder the phantom motor. And still the same...
They are used motors from a friend of mine. When starting up I hear cliks and the 3 original motors plus the phantom one are moving slightly as it shoud be. But when I activate the motors to take off only the three original motors start spinning and an error occurs. It happens every time no...
I’ve just bought 4 motrs and I was about to install them on my Platinum today when I red this post. Maybe it’s a fw issue because chazz’s connecion order Is the same. I am very concerned and I will watch this thread very carefully.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.