Here's my experience with the same error. I disassembled the whole bird checked and cleaned all the connections and reinstalled /calibrated EVERYTHING and now she flies like new. Apparently dji software dosent like when anything is disconnected
Wasn't using the extensions with the spring but I disassembled the whole bird checked and cleaned all the connections and reinstalled /calibrated EVERYTHING and now she flies like new. Apparently dji software dosent like when anything is disconnected
Just as an update, everything is fixed. Used the new chip, calibrated imu then compass then vision sensors and no more issues. Replaced a wobbly back leg while I was at it but I did clean all the connections with compressed air and alcohol and made sure everything was plugged in firmly. She...
Just wanted to update.... Changed the board back to the new one.... Completely tore the entire bird apart. Replaced a wobbly back leg while I was at it but made sure there were no kicked ribbon cables and double checked all the connections.. Sat it in the middle of my king size bed without the...
So I swapped back to the old board and still not getting a GPS signal. Everything looks normal under the bottom cover. Not exactly rocket science. Thinking about replacing the GPS unit. Very frustrating situation since the crash. Glad it's not my only bird.
Still no GPS.... Kind of stumped now. I'm going to put in the old chip and see if it changes anything and go from there. Location is showing up on the map but I'm still getting cannot take off with a check redundancy state error
I never took the top off and I had GPS before I opened the bottom to replace the chip and I connected to the assistant program and ralecalibrated the sensors and upgraded the firmware for the new chip, everything looked OK but I was still getting no GPS even after letting it sit outside powered...
OK if you haven't read any of my posts yet. I had a minor accident a couple months ago. Camera unit was completely replaced by drone nerds because they didn't know how to change the ribbon cable /video transmission cable. So I ended up getting a second mavic on ebay for $250 that had a missing...
So I figured it out. Took off the bottom plate and pushed on all the connections to make sure they were tight and calibrated the sensors. Still got the red light so I removed the SD card, formatted it on the pc, downgraded to factory defaults and then reinstalled the newest firmware and it seems...
I'm getting this error also after repair and firmware update.... Maybe issue with ios devices doing firmware updates and I've been doing updates on Android? I only get the error when I get about about 20 ft or so. Did a roof inspection today and didn't get the error at all but still experiencing...
Still getting the error but only after getting over about 20ft. Anything under that it's fine... I did a roof inspection today and before the sensor error I was having drifting problems and after I went above 20ft or so and got the error I didn't have any drifting issues
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.