Recent content by Pilot Zeg

As you can see from my old posts, my MA2’s gimbal motor (or whatever it is) is broken, but the camera works fine. Has anyone repaired the gimbal motor or whatever part is involved?? I have taken apart my MA2 and the repair looks tricky af. Just wondering if anyone can share their experiences...

Greetings Pilots, My MA2 gimbal motor is broken (camera still works but gimbal can't move) and I am looking to replace the camera. Would a MA2s camera work on a MA2 body? Safe flying!

Potentially a higher MP x6?

Thanks for the advice

My point exactly. This is why I am considering holding out for a couple months and maybe you people should do the same, if you want the latest and greatest :P

Well, do you recall the MA2 and MA2s release? If not: MA2 was released and then a few months later the MA2s was released. Unfortunately that was me: I splurged in the MA2 and didn’t want to upgrade to MA2s. So I just don’t want to be butt hurt again if DJI is potentially planning this..

This isn't explicitly a Pro

I might hold out.. but then 3-6 months is a long time :/

Does anyone think that the M3 is going to be quickly updated with a M3s model? The same scenario as what happened with the Air 2 and then the Air 2s being released a couple months later?

Hey mate thanks for the reply. Just wondering if you can tell me if there is any way to determine what is damaged when I pull apart the camera and gimbal? Also you may know what I need by this symptom: when I power on, the camera kinda just wobbles sadly every second and then stops and stays...

Hey lads, Was doing some risky flying above waves capturing cool photos and a huge wave crashed right below where my drone was and splashed it pretty bad (check out the pic). Nothing affected her flying ability, but the gimbal immediately started to malfunction by jerking to the left and right...