Recent content by RealSting

Thanks Cafguy.. much appreciated. I'll likely go for that charger shown in this thread.

not sure if this will help .. I typically fly my A2S batteries down to 22%. Then I put the batteries them back on the DJI standard charger (1 at a time) for 22 minutes and this brings the batteries to 2 solid + 1 blinking LED.

Can this be used with the Air 2S batteries? Amazon just MAVIC Air 2 ?!! There's no such drone as the MAVIC AIR 2S according the DJI website! MAVIC is another series of drones.

Am I going mad or something? I only see D-Log M on my A2s... Im sure there was a D-Log (Not D-Log M) option? Ive checked all resolutions and settings but can't find it?!

There’s no right or wrong way. For example, if you want to keep grading to a minimum and you use something like DaVinci Resolve, you can just set Resolve to manage colour for you (it will give you a good starting point in whatever colour space you’ve selected) and you can just tweak individuals...

That doesn’t look very good. I’d replace the controller if that’s an easy option. I’m using the standard controller and the issue I was having seems to have gone away with just updates - have tested it several times near and far and it seems to be ok, (for now at least!). However, as mine was...

I did a full charge on all 3 batteries on my original DJI charger, they were all fine, no flashing LED's or LED's on when charge was completed! Guess it's the Charger?!

Thank you.

so what you’re saying is that it could be the batteries? Hmmm.. all 3 were fine and I didn’t get that overcharge error when using the DJI charger before I recieved the multi charger. I will test again on the DJI charger, if I get the same issue, then surly the problem points to the battery. I...

I'm not entirely sure but it looks like you may be right.. after flying today I put my batteries back on using the storage mode (using the same battery ports on the charger), and it worked just fine with charger shutting off at a 2 solid LED's and 3rd LED blinking. So as you say, it could be...

Oh yes it is LED 3 !! So what does it mean for the batteries? Is it damaged? It’s hardly been used! It flew fine today. 3.7v on all cells I noticed as I landed on one of them.

I've just used my charger for the second time (and it is an Hanatora brand, just wasn't advertised as such), and the batteries in ports 2 and 3 had finished charging but their battery LED 1 is blinking 2 times a second. The battery in Port 1 was not blinking at all and also finished charging...

No, I followed the manufactures instructions and turned the batteries on first before attaching them. My point is that turning the battery on first may have caused that small spark when I attached the battery to the charger. The battery seemed to discharge ok and thus far I’ve not seen any error...

That’s exactly what I did and noticed the charger also said zero (0v) on its display panel. Wish they’d written that in the manual, even if it is bad English! I also noticed I got a small spark as I attached of my batteries to the contacts on the charger - I’m thinking it’s perhaps not a good...

Today was the first time I used the LYONGTECH Parallel Battery Charger for my Air 2S (charger pictured below) - I think many of you here have this same charger just maybe under a different name. I wanted to use the storage mode: The instructions say upon reaching storage charge (between 11.5 -...