Recent content by rodrigocoelho

it landed exactly on the radius I traced. But above a powerline. So, I coudn't find it. The arrow and blue mark is where it landed. Here is where it landed.

Updating. More than a month after I lost it, someone called me informing that he found a drone. It landed on the power line cables. After some powerful rains, it felt from the cables and was founded.

But a question. Anyone else had this problem? Anyone without this problem using latest firmwares?

I had the same problem. Solution: Rollback firmware to 1.04.02

Google can be wrong about altitude, since the home point should be on rooftop, and it is apparently on the 1st floor.

Yes, not possible to be the yellow.

I don't know why dji doesn't send Ac GPS coordinates do the control. This would really be a black box. Situations like that where the control disconnect from the mobile, the control would continue being a backup.

Yes, that's why I'm trying to interpret the fatal.log values, like @Oto is doing. I would like to estimate what moviments I did based on the angle, speed, time applying that movement and distance from home.

By the way, the sensors were off. That's probably why clearance was always 255

What mean the yellow line on your map? I was searching it more centered on the central line of the rth. 503m centered on it. But, if your yellow line shows some angle it was moving thru, it can be some meters aside from it. Help me understand your graph. And thank you so much for your help. You...

I'm thinking in use the angle x speed X time to estimate the distance ran from the rth original line. Based on the litchi log, I know the last position. From there, it started the rth until 473m, where is the mark on the attached image. From there I started blind moves. So, I need to estimate...

Rth was on 148m. Far above the buildings. How to you know the angles? How to you get it from the log?

Yes. Exactly that. And the landing was below 0, since the HP was on a rooftop of my apartment, on the 24 floor.

Hi Oto. Actually, it stopped the log recording as soon as the mobile (litchi) disconnected from the controller. The controller was still 100% with the drone, but without connection with the litchi. I'm sending too the fatal.log filtered from the moment I pressed the RTH.

Hi Oto, do you know which one is the bearing? The app log stopped as soon as the software disconnected from the RC.