Recent content by vincent pierre

In fact, I did have an message error, it was "sensor vision : disabled"

Hi thanks for your help, everything is fine now ) what was the probleme: a litle screw took one of the hair of the video cable, who stop the signal. I fixed it, and now it's just perfect. for my gimbale probleme, I realise that the litle black protection on top of the camera, made a little...

hi guys. everything all right. I realise that one of the hair of the video cable, was bloqued in a little screw, that i think bloqued the signal. I was in converstion with a guy to Santiago de chile, who is fixing drone problemes, he told me that It could be that, he had this problem. he was...

Hi good morning, I spend many night to understand what happens. I have a good new, and a bad one: the good one, I found my problem of gimbal, and fixed it. after changing the ribbon cable properly, I found that a little piece of black plastic on top of camera, made a little brake to the camera...

I look everywhere in the internet, there is few case of mine, and no answer for that, do you guys have any idea?

Is there any probleme message, if the video cable is not working?

the feed back video was just perfect before I fixed the gimbale. I didn't do nothing bad, very carefully do the manipulation, it's impossible I broke the video cable.

Hi good morning, sorry not to answer, I spend many night to understand what happens. I have a good new, and a bad one: the good one, I found my problem of gimbal, and fixed it. after changing the ribbon cable properly, I found that a little piece of black plastic on top of camera, made a...

all right thanks. look it so curious: i just switch on the mavic and it was working properly again: i did many tryed and it worked all times: but there is a lot of vibration and the camera is a little bit looking on the right side, I restart the mavic on factory state, and then on a stable...

hi thunderdrones. well when it was working the 2 times, no message, just perfect. then the message is only " over load gimbal problems

Hi everybody, may you help me ? after an overload gimbal, i decded to change the ribbon cable. I did it, switch on, and the camera after all the rotation stay perfecty staight and stabilised. it works. so my problem was the ribbon cable. it works only 2 times, switch on, switch off, without...