Hey All,
I have a Air 2S and today I just took it out and noticed that when I put it in RTH, it no longer goes to the altitude set in the settings. I have the Auto RTH altitude set to 180 ft. Today I was testing it at my RC club field, I took it off from the bed cover of my truck in the parking lot and flew it around. We have a covered pit area and i was hovering it over the runway at about 20ft and when I pushed the RTH button instead of climbing to 180 ft before returning to home, it just started to go straight to the bed of my truck without climbing, however that would have meant it would have flown straight through our pits. I immediately canceled the RTH and took it further out and tried again, same result. The only thing that has changed recently is I updated the aircraft and RC controller firmware. Anyone have any ideas?
Aircraft Firmware - 02.04.2700
RC Controller Firmware - 01.03.2100
I have a Air 2S and today I just took it out and noticed that when I put it in RTH, it no longer goes to the altitude set in the settings. I have the Auto RTH altitude set to 180 ft. Today I was testing it at my RC club field, I took it off from the bed cover of my truck in the parking lot and flew it around. We have a covered pit area and i was hovering it over the runway at about 20ft and when I pushed the RTH button instead of climbing to 180 ft before returning to home, it just started to go straight to the bed of my truck without climbing, however that would have meant it would have flown straight through our pits. I immediately canceled the RTH and took it further out and tried again, same result. The only thing that has changed recently is I updated the aircraft and RC controller firmware. Anyone have any ideas?
Aircraft Firmware - 02.04.2700
RC Controller Firmware - 01.03.2100
