- Joined
- Mar 4, 2017
- Messages
- 19
- Reactions
- 5
- Age
- 71
Based on the picture, I’m not convinced you broke anything off.
That picture shows what the bottom of the antenna normally looks like.
They tend to not like to be fiddled with, but try to reinsert. May be a bit loose from now on. I do think I’ve seen them on eBay, but whether the mm is the same as the other Mavic controllers, I haven’t determined yet. The antenna wire length itself could be the determining factor. The controller would need to be dismantled to install a new one.
And if you reinsert, keep in mind that it will face the opposite orientation of the other one.
You might as well just buy an antenna mod for $40 bucks like I did with my mavic air and my mavic air flys almost double what it did before and to be honest opening the controller up and installing everything was super easy,I thought it was gonna be hard and almost paid to send it out and have someone else do it until I watched a YouTube video and seen how easy it actually is,I mean super easy,and you’ll get way better range with signal and video transmission and mine isn’t even amplified just different internal antenna wires and 1 flat panel antenna and 1 long regular looking antenna and I couldn’t be happier ,just a thought!!!
That would be difficult at best. Because of its size and two separate solder connections to do, I wouldn’t even attempt that myself. I may have the internal board and wire from another controller that I don’t need that you are more than welcome to. I would need some pictures to see if they may be a match. Reinstalling a new one would require that you open the controller.
Thanks - Certainly an optionI hadn’t thought about !
Basically the same possibly as the mini. Several vids to watch.Can you point me to the one you used and the YouTube video ?
Yes, a good solution.
View attachment 86531
Had to dig through some old parts to find a few connectors.
Ready for some testing tomorrow.View attachment 86885View attachment 86886View attachment 86887