- Joined
- Aug 28, 2017
- Messages
- 52
- Reactions
- 19
- Age
- 74
I normally fly with Litchi but as far as I can see Litchi doesn't offer a controls calibration mode. Is this correct?
To add insult to injury when I go back to the DJI control app with the latest firmware I can no longer complete a calibration. After selecting calibrate it says to put controls at the centre and press OK. It then says to press START to begin (there is no START touch point). It offers two blue circles which usually direct me to put both sticks in the top RH corner. Then there is a long delay. It offers a touch button called NEXT which doesn't do anything. Sometimes the blue guide circles will move slowly down the RH side of the calibration boxes. Eventually though it reports that the calibration has timed out and says the calibration state will be reset.
It seems the controls do need to be calibrated as on touch down the motors no longer stop promptly when I bring the sticks 'back and inwards' as recommended.
Help!!
To add insult to injury when I go back to the DJI control app with the latest firmware I can no longer complete a calibration. After selecting calibrate it says to put controls at the centre and press OK. It then says to press START to begin (there is no START touch point). It offers two blue circles which usually direct me to put both sticks in the top RH corner. Then there is a long delay. It offers a touch button called NEXT which doesn't do anything. Sometimes the blue guide circles will move slowly down the RH side of the calibration boxes. Eventually though it reports that the calibration has timed out and says the calibration state will be reset.
It seems the controls do need to be calibrated as on touch down the motors no longer stop promptly when I bring the sticks 'back and inwards' as recommended.
Help!!
Last edited:
