Discovered something about Litchi today

[Brojon]

I started flying with Litchi and could not remember where the gimbal settings were.
So I switched to DJI Go4 and finished setting up the gimbal.
I went to look at the Airdata UAV data so I could number the new battery I flew with and - no data.
Tried it again - no luck.
Apparently if you start with Litchi but swap it out it never writes the data to Airdata.
For some reason I always assumed it was a continuous logging but it appears now that it is when the flight stops. I'm very curious how it knows that the flight is done. Perhaps start and stop motors.

 

[Exphantomflyer]

Im guessing it logs from when the motors start to when it stops, if you start the motors in Litchi then swap it doesn't see the motor stop so won't log

 

[ivanatora]

It's not start motors, because I have missions started with DroneHarmony or DroneDeploy and then switched to Litchi while the aircraft was still in the air. Got the airdata flight logged from this point on.

 

[Brojon]

So must be stop motors then. But there has to be something else to start collection because I've run multiple missions back to back and all the data is saved independently.