I started flying with Litchi and could not remember where the gimbal settings were.
So I switched to DJI Go4 and finished setting up the gimbal.
I went to look at the Airdata UAV data so I could number the new battery I flew with and - no data.
Tried it again - no luck.
Apparently if you start with Litchi but swap it out it never writes the data to Airdata.
For some reason I always assumed it was a continuous logging but it appears now that it is when the flight stops. I'm very curious how it knows that the flight is done. Perhaps start and stop motors.
So I switched to DJI Go4 and finished setting up the gimbal.
I went to look at the Airdata UAV data so I could number the new battery I flew with and - no data.
Tried it again - no luck.
Apparently if you start with Litchi but swap it out it never writes the data to Airdata.
For some reason I always assumed it was a continuous logging but it appears now that it is when the flight stops. I'm very curious how it knows that the flight is done. Perhaps start and stop motors.