DJI Mavic Pro, camera assembly hanging to the left.

[robauflog]

Hey all,

Have been using the Mavic Pro for about 3 days and its awesome... Only issue is the camera has is crooked, only noticed today with the cover off (gimbal protector) I have attached some images below to show you what it looks like. Basically the camera and gimbal are just hanging to the left. I have done all calibration IMU, gimbal and a full factory reset to see if it re-adjusts but no luck. Only gimbal roll has made the footage straight but the gimbal and camera are still crooked as shown. Just wondering if i should have this looked at by a DJI specialist? The footage is good, but under fast turning it takes its time to correct the roll on the footage so not sure if its broken from factory?

Cheers.

 

[msinger]

Check the gimbal board (above the gimbal) to ensure it's underneath all of the tabs. It should looks like this:

 

[VadMavic]

Hello, I have the same issue with the gimbal hanging to the left. Where you able to solve this issue?

 

[luc.carpenter]

I have the same issue, has anyone found a solution for this?

I have no crashed the drone, but noticed the camera hanging to the left after traveling. Was stored in proper case with camera protection cover in.

 

[MarkusAtHome]

I have the same issue, has anyone found a solution for this?

I have no crashed the drone, but noticed the camera hanging to the left after traveling. Was stored in proper case with camera protection cover in.

Check if the 4 gimbal damping elements are properly fitted and that the gimbal mount is properly seated. Post #2 is a great reference.