Error 180 Mavic 2 with CrystalSky running dji Go 4

jftman · Thursday at 12:22 AM

I have reupgraded the drone’s firmware. Running V01.00.0797
I am stuck with the Crystal Sky firmware bcuz when I try the update in settings it fails to check and says check my internet, but it is working. The version number is 02.04.06.00 with [email protected] ?

The drone motors start only in opti mode vision in doors.
As soon as I connect with GPS outside I get the error 180.
Supposedly the drone and CrystalSky firmware are running incompatible.

I try to locate the APK’s for both DJI Go 4, mine is 4.3.16 when it is up to 4.3.60 something.
I downloaded it onto a SD card in the Crystal Sky and click on it, but it does not fully install, it starts and the bar gies a good ways but POOPY.

After refreshing the drone firmware .0797 a box pops up saying Dji Go 4 must be v4.3.60 as of that note in Dji Assistant 2

I have read old post from like 4yrs ago but the info is not current I assume.

Can someOne provide guidance and how I must get straight?
I can fly with Litchi fine!

Cafguy · Thursday at 10:45 AM

One of your Firmwares is out of sync.
Upgrade or reinstall everything Drone, Controller, App, Monitor. Only use the DJI site to upgrade or Download your apps. I know nothing about the Crystal Sky monitor but make sure its running up to date Firmware for sure..

jftman · Thursday at 1:54 PM

Just doing the recommended refresh on controller. Current v01.00.0770
Question, Will dji assistant 2 recognize the Crystal Sky and update dji Go 4?

Cafguy · Thursday at 2:11 PM

I don't know that one...IT shooooould

jftman · Thursday at 4:36 PM

Just plodding along. A later Crystal Sky firmware version existed and I downloaded the zip file of Dji crystal sky firmware.
The Bin file I put on the SD card in slot one of CS.

SO NOW it is updated.
I HOPE it now will work but also I wish to update DJI GO 4 within the ap if possible.

The previous owner of this CS was an Inspire 2 pilot.
The Go4 ap wants to open with Inspire 2 on the Enter Device page. I wonder if the version on it is so early that MAVIC 2 is quirky?

I recall that the Drone refresh with Assistant 2 warned that DJI GO 4 must be v60 at least…mine is 4.3.16 LOL
Curiously when in settings I click Check fir Updates to go4 it says Latest Version now.

Can I uninstall 4.3.16 and install 60+?
Should I do a reset?

I opened Explorer on CS and selected the v60+ GO4 and no joy.
Why can’t it over write?
One possible issue is LITCHI is installed, but when powering up I can choose which ap to launch.

jftman · Thursday at 5:06 PM

Poopy. With respect to So Far.
I tried just connecting with Drone using old GO4 after the CS update success. No…….take off. Error 180.

I put in a fresh 100% CS battery and made sure in explorer while install v62 GO4 that it would get access to ALL.

I must now seek instructions for HOW to update GO4 on CS ,Crystal Sky. Since it is a native ap when new, you would think Dji Assistant 2 would do the deed.

jftman · Thursday at 5:21 PM

Ok, Better , in settings check for Update is responding.
System update is now installing.
The notes say support for Remote ID and perhaps this was one reason the drone would not launch. All a part of firmware inconsistancy.