I posted this on another thread... Not trying to duplicate but wanted to share my experience and what I did different before it began working again. I really hope this may help some of you and that it was not just a fluke. I can't figure out what else may have done it.
OK this is extremely odd and I can't figure out. Since I posted this comment earlier I took snap shot with gimbal setting when I went back to 0400 firmware from 0600. My camera was not level at all during hours of footage which caught my attention. Never had this happen before I updated to 0600. Here is after I went back to 0400.
Sooo.... I decided to go back to 0600 firmware again. Keep in mind 0600 firmware had this exact problem which I though originated from it. Well I re-calibrated IMU, Compass and Gimbal. I also set gimball to 0.0 before going back to 0600.
Now I have on 0600 the gimbal at 0.0 and it's level.
One thing I do notice that I had when upgrading first time to 0600 and when I went back to 0400 was that my firmware was hanging sometimes and I had to shut down DJI Assistant 2.0 and Mavic. I then realized there is an update to Assistant 2.0 that u was not aware of. I updated assistant to the latest version... 1.1.0-2.
When I updated back to 0600 this last time my firmware installed 0600 perfectly on Mavic and RC with no hang ups and my gimbal was perfectly level.
Just wanted to share. My issue is resolved for now.... I'm wondering if those experiencing issues had hang ups with firmware updates.
Mike
OK this is extremely odd and I can't figure out. Since I posted this comment earlier I took snap shot with gimbal setting when I went back to 0400 firmware from 0600. My camera was not level at all during hours of footage which caught my attention. Never had this happen before I updated to 0600. Here is after I went back to 0400.
Sooo.... I decided to go back to 0600 firmware again. Keep in mind 0600 firmware had this exact problem which I though originated from it. Well I re-calibrated IMU, Compass and Gimbal. I also set gimball to 0.0 before going back to 0600.
Now I have on 0600 the gimbal at 0.0 and it's level.
One thing I do notice that I had when upgrading first time to 0600 and when I went back to 0400 was that my firmware was hanging sometimes and I had to shut down DJI Assistant 2.0 and Mavic. I then realized there is an update to Assistant 2.0 that u was not aware of. I updated assistant to the latest version... 1.1.0-2.
When I updated back to 0600 this last time my firmware installed 0600 perfectly on Mavic and RC with no hang ups and my gimbal was perfectly level.
Just wanted to share. My issue is resolved for now.... I'm wondering if those experiencing issues had hang ups with firmware updates.
Mike
