This is an old problem but only today i decided to investigate more into this issue.
Long time ago i upgraded my mini (1) to 0600 and suddently it stopped working.
When i turn it on and sync with my RC i just cannot move the camera up or down BUT if i get into manual gimbal setup, i can move the camera with the arrows.
I think that, for some reasons, 0600 is incompatible with my drone but for obvious reasons, now i cannot downgrade it to any previous versions.
Any help?
Edit: there is a "fake" method that is going around in the forum to downgrade the firmware
i debunked it here with all assistant 2 consumer versions: Mavic Mini 1, can't downgrade from 01.00.0600
Long time ago i upgraded my mini (1) to 0600 and suddently it stopped working.
When i turn it on and sync with my RC i just cannot move the camera up or down BUT if i get into manual gimbal setup, i can move the camera with the arrows.
I think that, for some reasons, 0600 is incompatible with my drone but for obvious reasons, now i cannot downgrade it to any previous versions.
Any help?
Edit: there is a "fake" method that is going around in the forum to downgrade the firmware
i debunked it here with all assistant 2 consumer versions: Mavic Mini 1, can't downgrade from 01.00.0600